| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Exterior Panels/Trim | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000018XY006X |
| Title: EXTERIOR PANELS / TRIM: ROOF DRIP SIDE FINISH MOULDING: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP
NOTICE:
Only follow this procedure when replacing the clips.
(a) Remove the tape that remains on the moulding surface of the vehicle body, and then clean the surface with a non-residue solvent.
(b) Using an infrared light, heat the clip installation surface on the vehicle body and roof drip side finish moulding.
Heating Temperature:
|
Area |
Temperature |
|---|---|
|
Vehicle Body |
40 to 60°C (104 to 140°F) |
|
Roof Drip Side Finish Moulding |
20 to 30°C (68 to 86°F) |
NOTICE:
Do not excessively heat the vehicle body or roof drip side finish moulding.
(c) Install new clips in the positions shown in the illustration. Press in the clips by hand.
Specification:
|
Area |
Measurement |
|---|---|
|
a |
4.7 mm (0.185 in.) |
|
b |
5.1 mm (0.201 in.) |
|
c |
4.7 mm (0.185 in.) |
|
d |
5.0 mm (0.197 in.) |
NOTICE:
After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.
HINT:
- Minimum hardening time: 30 minutes
- Time needed for complete hardening: 24 hours
2. INSTALL ROOF DRIP SIDE FINISH MOULDING
|
(a) Engage the 2 clips and install the roof drip side finish moulding. |
(b) Remove the protective tape.
|
|